Introduction and application notes
In response to the requirements for environmental protection and automated operation, we have developed a series of full electric drive automatic workover rigs based on our core technologies such as a new type of power battery heavy-duty chassis, an on-board integrated automatic operation device, and energy management.
What this model is built to handle
When this model is shortlisted, the practical check is whether the full electric drive automated xj350 workver rigs supports the target duty without extra handling risk.
If the project already has a clear target for working envelope, this page becomes easier to use because the remaining checks are mostly about layout, control, and installation limits.
A stronger purchase case usually appears when the model gives a clearer answer on 350, service access, and the local delivery plan.
What buyers usually compare
Layout and handling
The field-deployable format reduces setup friction when the site needs a compact footprint.
Capacity boundary
Buyers should start with the working envelope because it defines the usable duty range.
Control package
The control package is arranged to match field-side decisions without unnecessary manual steps.
Maintenance access
Field service is simpler when the main components remain accessible after installation.
Where the package fits best
Typical duty
well servicing campaigns across land or desert blocks where a field-deployable format matters.
Field condition
The model is more suitable when field operation is part of the job requirement.
Project scenario
workover projects that need efficient rig-up and consistent pipe handling with electric-drive control and stable handling.
Main assembly and field interfaces
Principal unit
The main assembly carries the workover rig package function and defines the working layout of the unit.
Control system
The control package is tuned to keep the operator's tasks clear and the sequence consistent.
Mobilization format
Transport and setup remain important because the package has to fit the actual field logistics.
Field interfaces
Shared interfaces, hoses, cable points, or load paths should be checked together with the main specification.
