Injector Head | Clamp Chain Drive | CT Core Component

Coiled Tubing Injector: The Heart of the CT Unit

The coiled tubing injector (or injector head) is the component that grips the coiled tubing and pushes it into or pulls it out of the well. It is mounted above the BOP stack and provides the controlled force needed to run or retrieve the tubing. Without a working injector, the CT unit cannot function.

Coiled tubing injector head

How the Injector Works

The injector uses a pair of opposed chains with gripper blocks to grip the tubing:

  • Gripper blocks: Molded pads on the chains grip the tubing exterior
  • Chain drive: Hydraulic motors drive the chains in either direction
  • Pressure beams: Apply controlled clamping force on the tubing
  • Forward (inject): Chains move tubing downward into the well
  • Reverse (pull): Chains move tubing upward out of the well
  • Weight sensor: Measures the tension/compression on the tubing

The injector sits on top of the BOP stack. The tubing passes through the injector, through the BOP, and into the well. The driller controls injector speed and force from the control cabin.

Typical Specifications

Parameter Typical Range
Tubing size range 1" - 3.5" (25 - 89 mm)
Maximum pull force 30,000 - 120,000 lbs (136 - 544 kN)
Maximum push force 20,000 - 80,000 lbs (91 - 363 kN)
Maximum speed 30 - 60 m/min (100 - 200 ft/min)
Drive type Hydraulic motor, chain driven
Weight 2 - 5 tons

Frequently Asked Questions

What is the difference between an injector and a reel?

The reel stores the coiled tubing on a large spool. The injector grips the tubing and pushes it into or pulls it out of the well. They work together: the reel feeds tubing to the injector, and the injector controls the tubing going into the well. The reel is storage; the injector is the active control. Both are essential components of a CT unit.

What size tubing can the injector handle?

Most injectors cover a range of tubing sizes by changing the gripper blocks. A typical standard injector handles 1.5" to 2.875" tubing. Light duty injectors handle smaller sizes (1" to 2"). Heavy duty injectors handle larger sizes (2.875" to 3.5"). Changing gripper blocks takes 30-60 minutes. The injector's pull/push rating determines which tubing weight it can handle at depth.

How do I maintain the injector?

Regular maintenance includes: inspect gripper blocks for wear and replace when worn, check chain tension and adjust, lubricate chains and sprockets, inspect hydraulic hoses and fittings, and calibrate the weight sensor. Gripper blocks are wear items —they need replacement every 50-200 runs depending on tubing condition. Keep spare gripper blocks on hand. Clean and inspect the injector after each job.

Need a Coiled Tubing Injector?

Tell us your tubing size range and required pull force. Our engineering team will recommend the right injector and provide a quote within 48 hours.