Case Study

Electric vs Diesel Frac Skid

When an electric drive fracturing skid makes sense over a diesel pumper, and what power source you need to run it.

Detail

What changes when you go electric

A diesel pumper truck carries its engine on the truck: independent, mobile, and ready to go at any well site. An electric drive skid ties to an external power source, either the grid or a mobile turbine or generator package. That changes the economics and the logistics of the frac spread.

Electric drive wins on fuel cost, emissions and noise. It loses on the requirement to bring power to the well site. If the pad has grid access or can run a turbine, the electric spread pays back on fuel. If the location is remote with no power, the diesel pumper is still the practical choice.

Detail

When electric makes sense

Electric drive suits multi-well pads where the power source can serve several wells in a campaign. The pad builds out once, and the electric frac units plug in for the full program. This is the model on modern shale pads: lower per-stage fuel cost, lower emissions, quieter operation, and steady power quality that gives better pressure control.

Electric also suits locations where emissions or noise matter: urban-sensitive areas, offshore platforms, or regulated fields. The cost of bringing power to the site is spread across the multi-well program, which makes it work.

Detail

When diesel still wins

Diesel pumper trucks win on remote, single-well locations where bringing power is more expensive than the fuel they burn. They also win on short or scattered programs where building a permanent power setup does not pay back. The diesel pumper rolls on, runs the stage, and moves to the next location without a power infrastructure step.

The choice is not electric versus diesel in the abstract. It is: does this well program have the power infrastructure and the multi-well volume to make electric pay back? If yes, electric. If no, diesel. We supply both electric drive frac skids and the diesel alternative, and we will help you size the right spread for your field.

Buyer Checklist

Key parameters to confirm before ordering

  • Site power availability: grid / generator / none
  • Emission regulations: standard / low-emission / zero-emission
  • Mobility requirement: frequent moves / permanent pad
  • Operating cost target: capital vs fuel cost
  • Noise restrictions: urban / sensitive areas
Related Equipment

Equipment for this application

Need help choosing?

Send us your well program, site conditions, and operating requirements. Our engineers will recommend the right configuration within 48 hours.

Contact Our Engineers