Solutions

Shale Gas Fracturing Solution

A complete shale gas fracturing spread: electric drive frac skids, continuous sand blenders and high-pressure manifold iron, built for high-rate stimulation on land.

Overview

What shale gas fracturing demands

Shale gas and tight oil production depends on high-rate, high-volume hydraulic fracturing. A single stage may run thousands of horsepower at surface pressure above 100 MPa, combined with continuous proppant delivery from a blending unit. The spread has to hold that rate through a long stage without pressure fluctuations that affect fracture geometry, then move quickly to the next stage or the next well on a multi-well pad.

Modern shale operations have moved toward electric drive. Electric frac units tie into grid or mobile power generation, cut diesel consumption and emissions, and deliver steadier power than diesel-driven units. The continuous blending unit has to deliver consistent slurry concentration at high rate, and the high-pressure iron has to survive repeated pressure cycles without fatigue failure.

Overview

The complete fracturing spread

A shale frac spread is more than a row of pumper trucks. It needs the pumper units for pressure, the blending equipment for proppant delivery, the manifold iron to route flow to the well, and water and chemical handling for the fluid. Our line covers the pumping and blending core, with electric drive options for operators targeting lower emissions and lower fuel cost.

Electric drive frac skids use motor-driven plunger pumps tied to a power source, either site grid or a mobile turbine or generator package. They offer smoother pressure control, faster rate response and lower running cost than diesel units, at the price of requiring a power source at the well site. Sand blending skids deliver proppant and water at controlled ratios, with continuous operation across the stage.

Overview

Multi-well pad operation

On a modern shale pad, several wells share the same surface location. A diversion manifold routes pumper flow between wells without moving the entire spread between stages. Combined with fast-moving frac units that reset between stages, this cuts non-productive time across the pad. Tell us your stage rate, well count, and whether the pad has grid power or requires self-generation, and we will configure the spread and the manifold layout.